Service

FEMA Floodplain Engineering and Map Changes

Preparation and submittal of FEMA Letter of Map Change applications - amendments, revisions based on fill, conditional and final map revisions - with the survey, modelling and certifications each one requires. FEMA issues the determination.

Two drawings side by side. On the left a flood insurance rate map of a small subdivision, where the special flood hazard area crosses the rear of the subject lot, with base flood elevation lines across the floodplain and a section line cut through the property. On the right that section, showing the surveyed natural grade, engineered fill raising the building pad, and the lowest floor set above the base flood elevation.

What a FEMA flood map change is

A FEMA flood map change is a formal amendment or revision to the effective Flood Insurance Rate Map covering a property or a reach of watercourse. That map is the legal basis for floodplain regulation and for the federal mandatory purchase of flood insurance, so when it no longer describes the ground — because it was drawn from data too coarse to see a particular lot, because engineered fill has been placed, or because a project will change the floodplain itself — the remedy is an application to FEMA supported by survey and engineering analysis. RSP Engineers prepares and submits those applications and the analysis behind them. FEMA issues the determination.

The applications we prepare

Letter of Map Amendment

For ground that is naturally above the base flood elevation and was mapped into the special flood hazard area because the mapping was never fine enough to see it. Nothing is built and no fill is placed; the application demonstrates, on surveyed elevations, that the map and the ground disagree.

Letter of Map Revision Based on Fill

For a property raised above the base flood elevation by engineered fill. Alongside the survey and the analysis this one needs the community’s own acknowledgment that the fill was placed in compliance with its floodplain ordinance — a requirement applicants routinely meet late, because it sits with the local floodplain administrator rather than with the engineer.

Conditional amendments and conditional revisions based on fill

The same two questions asked before the work is done rather than after. A conditional application returns FEMA’s comment on whether the proposed fill or the proposed structure would qualify, so that a purchase, a design or a financing decision is not resting on an assumption about the flood zone a finished project will sit in.

Conditional Letter of Map Revision

Required before construction where a project would alter a regulated floodway, raise base flood elevations, or otherwise change the floodplain as it is mapped. It carries hydrologic and hydraulic analysis of both existing and proposed conditions, certified by a professional engineer. On the projects that need one it usually governs the schedule, because the work that depends on it cannot responsibly start until FEMA has commented.

Letter of Map Revision

The revision itself: submitted on as-built conditions once construction is complete, or on better data where no construction is involved at all — a new survey, a corrected model, or a channel or culvert that the effective map does not reflect.

The supporting work

  • Elevation Certificates — the surveyed record of a building’s elevations relative to the base flood elevation, which a map amendment, a floodplain permit and an insurance rating each depend on. Prepared from survey by a licensed surveyor and certified by whoever the form and the state allow to certify it.
  • No-rise certifications — for development in a regulated floodway, the hydraulic analysis and the engineer’s certification that the project produces no increase in base flood elevation. Where the analysis shows a rise, it shows it, and the project changes or goes the conditional revision route instead.
  • Floodplain development permit support — the drawings, elevations and calculations the local floodplain administrator needs, and the correspondence that goes with them.
  • Hydrologic and hydraulic modelling — existing and proposed conditions, built to the standard a map revision submittal has to meet rather than to the standard a local drainage review would accept.

Who commissions this work

An owner or developer who needs the map corrected

A property is mapped into the special flood hazard area and the owner believes it should not be, or has placed fill so that it no longer should be. What follows from the map is a mandatory insurance purchase, elevation requirements on anything built, and a constraint that attaches to the property at sale. The application is the route to having the record match the site.

A developer or a community changing the floodplain

A project will encroach on a floodway, modify a channel, replace a crossing or fill part of a mapped floodplain. Here the sequence is fixed and getting it wrong is expensive: the conditional revision is obtained first, the work is built to what FEMA commented on, and the revision follows on as-built conditions. A project built before the conditional step is a problem discovered at the worst possible moment.

What a submittal contains

The FEMA forms for the application type, the survey and elevation data, the hydrologic and hydraulic models of existing and proposed conditions with the certification each requires, annotated mapping showing the revised boundary, and the community documentation that has to travel with it. Where something cannot be established from the available data, the submittal says so and says what would establish it, rather than carrying an assumption into a federal determination.

What this service does not do

RSP does not issue the determination and cannot assure the outcome of one. FEMA issues the determination, on its own review, and nothing on this page should be read as a prediction of what it will decide or of when. RSP is not a FEMA contractor, agent or representative.

A determination that lifts the federal mandatory purchase requirement does not stop a lender requiring flood insurance of its own accord, and it does not make a property safe from flooding. The map describes a regulatory boundary, not a promise about water.

Professional licensure is jurisdiction-specific. A submittal carrying an engineer’s certification is certified by RSP only in states where RSP holds licensure; elsewhere RSP prepares the analysis and the submittal for certification by a licensed engineer. Tell us where the property is and we will confirm how the work would be covered before any scope is agreed.

Why RSP is asked to do this

Because the modelling a map revision rests on is the modelling RSP already does. The hydrologic and hydraulic work behind a conditional revision is the same discipline as storm drainage design, held to a federal submittal standard rather than a local review one, and the floodplain constraints that drive it are the ones planning and site investigation establishes before a site is bought. It is part of RSP Advantage, how every RSP project is delivered.

Gas station with fuel canopy and convenience store on a commercial corner lot

Market

Commercial Property Civil Engineering

RSP Engineers provides full-site development for your commercial needs, including restaurants, gas stations, and office buildings.

See how we help
Aerial view of a lakeside single-family residential subdivision

Market

Residential Civil Engineering

RSP Engineers residential civil engineering for homes and communities. We create desirable neighborhoods through site planning and infrastructure design.

See how we help
Image from "LOMR and LOMA Applications in Florida Development" (alt text pending review)

LOMR and LOMA Applications in Florida Development

Understand how LOMR and LOMA applications affect development in Florida. Learn when to apply, what documentation is needed, and how civil engineers guide FEMA map revisions.

Read article →
civil engineer development

Can You Build in a Flood Zone? What Engineers Say

Wondering if you can build in a Florida flood zone? Learn what civil engineers say about permitting, drainage plans, elevation, FEMA rules, and how to build safely and legally.

Read article →
What is the difference between a LOMA and a LOMR-F?

What raised the ground. A Letter of Map Amendment is for land that was always naturally above the base flood elevation and was mapped into the flood zone because the mapping was too coarse to see it. A Letter of Map Revision Based on Fill is for land raised above it by engineered fill, and it additionally needs the community’s acknowledgment that the fill met its floodplain ordinance.

Do I need a CLOMR before I build?

If the project would alter a regulated floodway, raise base flood elevations or otherwise change the mapped floodplain, yes - the conditional revision comes first, the work is built to what FEMA commented on, and the final revision follows on as-built conditions. Building first and applying afterwards is the sequence that turns a procedural step into a serious problem.

Will a map change remove my flood insurance requirement?

A determination in your favour lifts the federal mandatory purchase requirement, but a lender may still require flood insurance of its own accord, and the property is no safer from water than it was. The map describes a regulatory boundary, not the behaviour of a storm.

How long does FEMA take to issue a determination?

FEMA controls its own review and we do not quote a time for it. What we will tell you at the outset is which application applies, what the submittal has to contain, and which pieces - survey, community acknowledgment, modelling - are the ones that usually hold an application up before it ever reaches FEMA.

What is an Elevation Certificate and when is one needed?

It is the surveyed record of a building’s elevations relative to the base flood elevation. A map amendment, a local floodplain development permit and an insurance rating each depend on one, so it is often the first document to obtain rather than the last.

Tell us about the property

Send us the address, what the effective map shows today and what you need it to show - or what the project will change about the floodplain - and we will come back on which application applies and what it would take.

Stormwater Plan

civil

Storm Drainage Design

Expert stormwater design by RSP Engineers ensures effective drainage and management for your project.

Explore service
Civil Engineering Firm

civil

Engineering Land Development

RSP Engineers provides engineering land development services to transform properties effectively.

Explore service